Kegs to Kettles

Davin · Post by **Davin** » Wed May 21, 2008 4:00 pm

My kegs came in today. Anybody have a good place to get the lids cut out in case my guy falls through? I was worried about how they would fit on my current burner, but its actually very secure.

[albumimg]273[/albumimg]

Chris Alvey · Post by **Chris Alvey** » Tue May 27, 2008 7:18 am

I think an angle grinder is the way to go for cutting off the tops.

Make sure the pressure is out !

Davin · Post by **Davin** » Tue May 27, 2008 9:59 am

I ended up using a local welding shop. They did it for a reasonable price and quickly.